FAQs » ADSL Modem Settings

Frequently Asked Questions


Parent Categories

TOP LEVEL

Category: ADSL Modem Settings

Page 1 of 1 - Items per page:
Q

3Com

Q

Billion

Q

D-Link

Q

Linksys

Q

Net Gear

Q

Netcomm

Q

Speed Touch v.585

Q

TP-LINK router

A

How to configure PPPoE on TP-LINK ADSL Modem Router

 

Step 1 Open the web browser and type the IP Address of the device in the address bar (default is 192.168.1.1) then press Enter .
Step 2 Type the username and password in the login page, default username and password are both admin in lower case, then click OK to log into the device.
Step 3 Click Quick Start on the upper side.

 

Step 4 Click RUN WIZARD and click NEXT to configure the ADSL Router.

 

 

Step 5 You may change the admin account password by entering in a new password. If you wouldn’t like to change, type the default password and click NEXT.

Step 6 Select the correct Time Zone and click NEXT.

Step 7 Select PPPoE/PPPoA and then click NEXT.

Step 8 Input the Username and Password provided by your ISP. Input correct VPI = 0 and VCI = 35 which also are provided by your ISP. Then click NEXT.

 

 

Step 9 If your ADSL Router supports wireless function and you want to connect to it wirelessly, please set Access Point Activated and configure the security. Here we take WPA-PSK, TKIP/AES as example. Type in your key and  click NEXT.

 

Step 10 Click NEXT and Close to save the settings.

 

 

 

How to reset TP-LINK products to factory defaults(Forgot/Lost Password)

Note: If you reset the device, the device will return to factory defaults, you will lose all your settings.

1. By pressing the RESET button on the rear panel.
Step 1 Turn off the modem (pull the power out of the unit ).
Step 2 Press and hold the reset button on the rear panel with a pin, while holding down the reset button turn on the modem (plug the power back into the unit). It is important that you continue to hold down the reset button for approximately 15 seconds.  

Step 3 Release the reset button and wait for the device to reboot.
 
2. By using Web-based Utility.
Step 1 Open the web browser and type the IP address of the wireless router in the address bar (default is 192.168.1.1). Press Enter.
Step 2 Type the username and password in the login page, the default username and password both areadmin,then click OK to connect to the device..
Step 3 Click Management->Settings->Restore defaults on the left side, and then click Restore to reset the device to factory defaults.

Note:
1. Make certain that the router is powered on before it restarts completely.
2. The default IP address is 192.168.1.1, and the default login username and password both are admin (all lower case).
3.  Ensure that the IP address of your computer is in the same subnet with the device.  It means that your computer should have an IP address 192.168.1.X (X is in range of 2~253), and the subnet mask is 255.255.255.0, the default gateway should be 192.168.1.1 which is the IP address of the router.
 
b

Author: Sahara Net
Q

U.S.Robotics

Page 1 of 1 - Items per page:
Show ALL Answers  |   TOP   |  Back
Click the question to reveal the answer, click the question once more to hide.